20041124-allegro-01-cuttingmidmylars:
To start the mid-panel build, we need to again cut mylar shims for the spar bottoms. Measure the width of the spar on the plans, and cut your mylars accordingly. My plans indicated 6mm wide spars. I mark my mylars with a fine-point felt tip pen, and then using a sharp utility knife and a good straightedge, I made many light cuts while applying pressure to the straightedge (mylar is slippery).
20041124-allegro-01-cuttingmidmylars:
To start the mid-panel build, we need to again cut mylar shims for the spar bottoms. Measure the width of the spar on the plans, and cut your mylars accordingly. My plans indicated 6mm wide spars. I mark my mylars with a fine-point felt tip pen, and then using a sharp utility knife and a good straightedge, I made many light cuts while applying pressure to the straightedge (mylar is slippery).